BMW X3 Service & Repair Manual: Replacing suction pressure sensor on intake plenum (N55)

BMW X3 Service & Repair Manual / Electrical / Electronic switching or control units / Replacing suction pressure sensor on intake plenum (N55)

Necessary preliminary work:

  • Read out the fault memory of the DME control unit.
  • Switch off ignition.
  • Remove INTAKE FILTER HOUSING .

Release connector (1) and remove.

Release screws and pull suction pressure sensor (2) out of intake plenum.

Electrical

Installation note:

Check sealing ring for damage. Replace damaged sealing ring.

When installing, coat sealing ring with suitable lubricant.

Electrical

NOTE: Reassemble the vehicle.

Check stored fault message.

Delete fault memory.

    Replacing suction pressure sensor on intake plenum (N20, N26)
    Necessary preliminary tasks: Read out the fault memory of the DME control unit. Switch off ignition. Partially undo the acoustic cover. Unl ...

    Replacing suction pressure sensor on pressure pipe (N20, N26)
    Necessary preliminary tasks: Read out the fault memory of the DME control unit. Switch off ignition. Unlock connector (1) and remove. Unfa ...

    Other materials:

    BMW X3 Service & Repair Manual > Rear axle: Socket wrench
    Socket wrench AM NOTE: (Socket wrench) Socket wrench Minimum set: Mechanical tools AM NOTE: (Socket wrench, hex socket, 6 mm) discontinued, available as part of set of special tools only Socket wrench Minimum set: Mechanical tools AM NOTE: (Socket wrench SW18) discontinued, available a ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2024 Copyright www.bmwx3tech.com - 0.0086