BMW X3 Service & Repair Manual: Replacing suction pressure sensor on pressure pipe (N20, N26)

BMW X3 Service & Repair Manual / Electrical / Electronic switching or control units / Replacing suction pressure sensor on pressure pipe (N20, N26)

Necessary preliminary tasks:

Read out the fault memory of the DME control unit.
Switch off ignition.

Unlock connector (1) and remove.

Unfasten screws (2).

Pull suction pressure sensor (3) out of pressure pipe.

Electrical

Installation note:

Check sealing ring for damage. Replace damaged sealing ring.

When installing, coat sealing ring with suitable lubricant.

Electrical

NOTE: Reassemble the vehicle.

Check stored fault message.

Delete fault memory.

Replacing suction pressure sensor on intake plenum (N55)

Necessary preliminary work: Read out the fault memory of the DME control unit. Switch off ignition. Remove INTAKE FILTER HOUSING . Release ...

Preheating relay

REPLACING PREHEATING CONTROL UNIT (N47D20 O1) Necessary preliminary tasks: Switch off ignition. Remove INTAKE SILENCER HOUSING . Release pos ...

Other materials:

BMW X3 Owners Manual > Settings on the Control Display: Time
Setting the time zone 1. "Settings" 2. "Time/Date" 3. "Time zone:" 4. Select the desired time zone. The time zone is stored. Setting the time 1. "Settings" 2. "Time/Date" 3. "Time:" 4. Turn the controller until the desired hours ...