BMW X3 Service & Repair Manual: Removing and installing/replacing starter motor (N20, N26)
Necessary preliminary tasks:
- Switch off ignition.
- Disconnect BATTERY NEGATIVE LEAD .
- Remove INTAKE PLENUM .
Unlock connector (1) and remove.
Release nuts (2) and disconnect positive battery cables.
Release screws (3).
Feed out starter motor and remove.
Installation note:
Check starter pinion and ring gear for damage. Replace starter motor if necessary.
Only during starter replacement and on vehicles with MSA (automatic engine start-stop function):
- Use BMW diagnosis system to reset the starter counter.
Handling components after flood damage
Flood damage can occur if the permissible fording depth of a vehicle is exceeded. Ingress of water can cause
damage to the engine (water shock) or ...
Removing and installing/replacing starter motor (N47 D20 O1)
Necessary preliminary tasks:
Switch off ignition.
Disconnect BATTERY NEGATIVE LEAD .
Remove REINFORCEMENT PLATE .
Release nut (1) and remov ...
Other materials:
BMW X3 Service & Repair Manual > Steering wheel for airbag: Removing and installing/replacing airbag unit
WARNING:
Observe the following instructions to avoid any risk of injury by the airbag unit.
Comply with safety regulations for handling components with gas
generators.
Do not exert any force on the airbag unit.
Use only specified tools for releasing the airbag unit.
NOTE:
Incorrect ...
BMW X3 Owners Manual
BMW X3 Service & Repair Manual
