IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .
Necessary preliminary tasks:
Overview of wiring harness section for ignition and injectors.
Unlock and remove connector (1) from control unit.
Release wiring harness from clamps (1).
NOTE: This procedure is applicable to all cylinders.
Unlock and disconnect connector (1) at injectors.
Slacken nut (1) and remove ground cable (3).
NOTE: This procedure is applicable to all cylinders.
Release connector catch (1) at ignition coil (2) and pull off connector.
Unlock retaining lug (1) in direction of arrow.
Pull cable channel (2) from cylinder head cover.
Pull out and remove wiring harness section for injectors and ignition coils.
NOTE: Check stored fault messages.
Clear diagnostic fault entries from fault memory.
BMW X3 Service & Repair Manual > Front axle: Pin
Pin AM
NOTE: (Replacement pins) Deletion, only available via tool set
Pin Minimum set: Mechanical tools AM
Replaced by: 83302213023
NOTE: Spare part set for basic device (2 locking pins and 1 O-ring) will be available
under a new order number 83 30 2 213 023 as of July 2011
SI number
01 16 ...