IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .
Necessary preliminary work:
Unlock rear plug (1) from the control unit and disconnect.
Release rear wiring harness from intake plenum.
Release nuts (1) and remove earth cable.
Unlock all connectors from ignition coils and injectors and detach.
Unclip wiring harness (2), feed out and remove.
NOTE: Check stored fault messages.
Delete fault memory.
BMW X3 Service & Repair Manual > Pedals: Device
Device AM
NOTE: (Drilling device) For brake pedal, additional locking pin.
Consisting of:
1. Template
NOTE: (Drilling template, left-hand drive vehicle)
2. Drill bit
NOTE: (Steel drill bit) Ø 3 mm
3. Holding sleeve
NOTE: (Clamping sleeve Ø 3x30 1 set (10 units))
4. Templ ...