BMW X3 Service & Repair Manual: Gauge

Gauge Mechanical tool

NOTE: (Gauge for pedal sensor)

Storage Location

Y3

SI number

01 04 87 (780)

Electrical

Gauge Mechanical tool

NOTE: (Test gauge) for wiring harness, pedal sensor

GUARD

Guard AM

NOTE: (Protective gloves)

Electrical

Guard MP

NOTE: (Reverse polarity protection) Retrofit kit with reverse polarity protection diode for installation into adapter cable 12 6 411, to adjust it to performance data of switching device 12 6 050. Identification: Red heat-shrink tubing Only available as part of complete tool set 12 6 410 - (83 30 0 491 148).

Guard AM

NOTE: (Protective gloves)

    Device
    Device Mechanical tool NOTE: (Turning device) for ignition distributors - H. Korer NOTE: (retainer) For holding the ignition distributor during re ...

    Holder
    Holder AM NOTE: (Counter support for alternator with freewheel) Counter support for alternator with freewheel N42 engine (with external serrations ...

    Other materials:

    BMW X3 Service & Repair Manual > Driveline+Axles: Specified grease
    GREASE FOR PROPELLER SHAFT (FLEXIBLE COUPLING (RUBBER DOUGHNUT) CENTER BEARING AND SPLINE END) Use one of the following greases for greasing the propeller shaft center bearing or locating pin of the transmission output flange and the splines of the propeller shaft spline end. GREASE FOR PROPELLE ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2021 Copyright www.bmwx3tech.com - 0.0038