REMOVING AND INSTALLING ANTI-ROLL BAR LINK FOR LEFT OR RIGHT ANTI- ROLL BAR
IMPORTANT: Risk of damage!
- Avoid bending the head of the anti-roll bar during assembly!
- An impact screwdriver must not be used!
Detach bracket for brake hose on spring strut.
IMPORTANT: When releasing push rod screw connections (1) and (3), it is essential to counterhold with a Torx tool.
Slacken nut (1).
Release nut (3) and remove anti-roll bar link (2).
Installation note: Replace self-locking nuts.
REMOVING AND INSTALLING/REPLACING FRONT STABILIZER
IMPORTANT: To avoid complaints being made by the customer about noise, set the vehicle on its wheels and tighten down the stabilizer mounting to specified torque.
Necessary preliminary tasks:
N52T, N55: Loosen screws on the coolant pipe (1).
BMW X3 Service & Repair Manual > Electronic switching or control units: Removing/replacing knock sensors (N55)
Necessary preliminary tasks:
Read out the fault memory of the DME control unit.
Switch off ignition.
Remove INTAKE PLENUM .
Vehicles with the Bosch high pressure pump only :
Remove HIGH PRESSURE PUMP .
Unlock connector (1) and remove.
Feed out connector (1) behind feed line, remove ...