WARNING: Danger to life! Read and follow operating instructions for vehicle hoist.
Do not exceed approved load-carrying capacity and load distribution of vehicle hoist.
Weight compensation may be necessary due to the loading situation of the vehicle.
This also applies in the event of considerable removal of parts or conversions on the vehicle.
NOTE: The vehicle hoist must comply with the relevant statutory/country-specific accident prevention regulations and be serviced according to the regulations.
IMPORTANT: Risk of damage! Before driving onto a vehicle hoist, make sure there is sufficient ground clearance between the vehicle hoist and the vehicle.
The vehicle may only be raised with the vehicle hoist at the four jacking points.
Necessary preliminary work:
IMPORTANT: All four jacking points (1) must be available! Never raise the vehicle without the jacking points (1)!
IMPORTANT: Risk of damage! Align support plates (2) of lifting platform arms to jacking points (1) in such a way that no adjoining components are touched and thereby damaged.
In hybrid cars there is a risk of damage to the high-voltage component behind the underbody panelling!
IMPORTANT: Risk of damage! Align the rubber block (2) with the jacking points (1) in such a way that no adjoining components are touched and thereby damaged.
Never raise the vehicle without rubber blocks (or rigid foam blocks)! There is a major risk of damage to the vehicle underbody!
In hybrid cars there is a risk of damage to the high-voltage component behind the underbody panelling!
BMW X3 Service & Repair Manual > Output shafts: Removing and installing/replacing both output shafts
IMPORTANT:
The RADIAL SHAFT SEAL FOR THE OUTPUT SHAFT should be renewed every
time the output shaft is removed and installed.
The circlip of the output shaft must be replaced after re-installation.
NOTE: The procedure is described in PRESSING OUTPUT SHAFT OUT OF DRIVE
FLANGE AN ...