BMW X3 Service & Repair Manual: Pressing output shaft out of drive flange and drawing in

BMW X3 Service & Repair Manual / Suspension / Output shafts / Pressing output shaft out of drive flange and drawing in

Necessary preliminary tasks:

  • Remove REAR WHEEL .
  • Remove REAR AXLE FINAL DRIVE.

IMPORTANT: Always place a new circlip on the output shaft reinstalling!

If necessary, remove visual protection cap (1).

Suspension

IMPORTANT: Expand anti-twist lock sufficiently to avoid damaging thread when releasing collar nut (1).

Activate parking brake and release collar nut (1).

Installation note:

Lightly oil the gearing at the shaft journal.

No oil permitted on thread of shaft journal or collar nut.

Replace collar nut (1) by positive peening at flat areas of output shaft.

Suspension

Special Tools:

  • Hydraulic unit - 81 64 2 155 744
  • Adapter kit 1 - 81 64 2 155 745
  • Adapter kit 2 - 81 64 2 155 746

The following work steps describe pressing out the output shaft:

Suspension

The following tools are required to press out the output shaft from the drive flange for arrangement:

Vehicle components:

Suspension

Required components for all models and types:

Suspension

  • Secure output shaft against falling out.
  • Press out output shaft with hydraulic unit.

The following work steps describe drawing in the output shaft:

Suspension

The following tools are required to fit the output shaft in the drive flange, see Fig. 61 for arrangement:

Vehicle components:

Suspension

Required components for all models and types:

Suspension

Components specific to model and type (thread diameter, output shaft):

Suspension

Suspension

IMPORTANT: Risk of damage!

Due to the technical requirements, the special tool used, sleeve G, is relatively thin-walled. To ensure that the load limit of the tensioning sleeve is not exceeded when drawing in the output shaft, it is essential to use adapter 81 64 2 318 661 in combination with a torque wrench.

Fit adapter with torque wrench to hydraulic unit.

Set torque wrench to 20 Nm.

Draw in output shaft with hydraulic tool until the torque wrench is activated.

Tighten collar nut (1), activate parking brake for this purpose.

Installation note:

Renew collar nut (1), apply a light coating of oil to collar nut contact surface and tighten.

No oil permitted on thread of shaft journal or collar nut.

Secure collar nut (1) by positive peening at flat areas of output shaft.

Suspension

    Output shafts
    ...

    Removing and installing/replacing both output shafts
    IMPORTANT: The RADIAL SHAFT SEAL FOR THE OUTPUT SHAFT should be renewed every time the output shaft is removed and installed. The circl ...

    Other materials:

    BMW X3 Owners Manual > Voice activation system: One example: open the tone settings
    Via the main menu The commands of the menu items are spoken just as they are selected via the controller. 1. Turn on the Entertainment sound output if needed. 2. Press button on the steering wheel. 3. Radio 4. Tone Via short command The desired tone settings can also be started via a sho ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2020 Copyright www.bmwx3tech.com - 0.0069