BMW X3 Service & Repair Manual: Replacing rubber mount for wishbone in wheel carrier

BMW X3 Service & Repair Manual / Suspension / Control arms and struts / Replacing rubber mount for wishbone in wheel carrier

Special tools required:

  • 0 496 553
  • 0 496 554
  • 2 293 768
  • 2 293 777
  • 2 293 770

Necessary preliminary tasks:

  • Release WISHBONE ON WHEEL CARRIER.

Withdrawing rubber mount:

Pull out rubber mount with special tools 0 496 553, 0 496 554, 2 293 768 and 2 293 777 out of wheel carrier against direction of travel (F).

Suspension

Installing rubber mount:

IMPORTANT: Alight slot (1) of rubber mount parallel to wheel carrier.

Suspension

Pull in rubber mount (1) against direction of travel (F) with special tools 0 496 553, 0 496 554, 2 293 770 and 2 293 777 up to limit position.

Suspension

After installation:

  • Perform WHEEL ALIGNMENT .
    Replacing rubber mount for trailing arm in wheel carrier
    Special tools required: 0 496 553 0 496 554 2 293 777 2 293 768 2 293 772 Necessary preliminary tasks: Remove REAR WHEEL . Remove ...

    Axle mounting
    ...

    Other materials:

    BMW X3 Service & Repair Manual > Transfer case, general: Safety instructions for handling oil
    WARNING: DANGER OF POISONING if oil is ingested/absorbed through the skin! RISK OF INJURY if oil comes into contact with eyes and skin! Recycling: Observe country-specific waste disposal regulations. Measures if oil is unintentionally released: Personal precautionary measures: Danger of slip ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2021 Copyright www.bmwx3tech.com - 0.0077