BMW X3 Service & Repair Manual: Removing and installing/replacing upper section of steering column shroud

BMW X3 Service & Repair Manual / Suspension / Steering column / Removing and installing/replacing upper section of steering column shroud

Move steering column in "bottom" and "extended" position.

Pull steering column gap cover up carefully and clip out gap cover.

Suspension

Pull steering column shroud (1) up.

Clip steering column gap cover (1) out of steering column shroud upper section.

IMPORTANT: Risk of damage! Carefully pull steering column shroud upper section (1) upward at rear and clip out.

Suspension

    Removing and installing/replacing universal joint with corrugated tubing
    IMPORTANT: After the steering shaft has been loosened on the steering gear/steering column, do not turn the steering wheel any more. If th ...

    Replacing steering column adjustment lever
    Necessary preliminary tasks: Remove : trim panel for pedal mechanism. Release nuts (1) from footwell and detach adjustment lever. Installation ...

    Other materials:

    BMW X3 Service & Repair Manual > Steering and wheel alignment: Bush
    Bush AM NOTE: (slip bush) For fitting the snap ring to the lower steering shaft bearing - Model: 2500... 3.0 CSi Deletion, only available via tool set Storage Location A8 Bush Mechanical tool NOTE: (Slip bush) For fitting steering angle sensor on steering column Storage Location A3 SI n ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2024 Copyright www.bmwx3tech.com - 0.0108