BMW X3 Service & Repair Manual: Replacing oil accumulator (GA8HP45Z)

IMPORTANT:

  • Do not let skin come in contact with transmission oil and do not inhale fuel vapors.
  • Wear protective gloves.
  • Ensure adequate ventilation.

IMPORTANT: Applicable to vehicles from 08/2011 Remove transmission oil sump only after it has cooled down.

After completion of repair work, check TRANSMISSION OIL LEVEL .

Use only the approved TRANSMISSION OIL .

Failure to comply with this requirement will result in serious damage to the automatic transmission!

Installation note: The transmission oil sump must be renewed every time it is removed.

Necessary preliminary tasks:

  • REMOVE TRANSMISSION OIL SUMP.

Recycling:

Catch and dispose of escaping transmission oil.

Observe country-specific waste disposal regulations.

Release screws (1) (M6x20).

Release screw (2) (M6x59).

Carefully unlock connector (3) with screwdriver.

Carefully pull out oil accumulator.

IMPORTANT: Mounting bolts of oil accumulator must be replaced after removal.

Transmission

    Hydr/el control components/elements
    ...

    Replacing oil reservoir (GA8HP70Z)
    IMPORTANT: Do not let skin come in contact with transmission oil and do not inhale fuel vapors. Wear protective gloves. Ensure adeq ...

    Other materials:

    BMW X3 Service & Repair Manual > Steering and wheel alignment: Bush
    Bush AM NOTE: (slip bush) For fitting the snap ring to the lower steering shaft bearing - Model: 2500... 3.0 CSi Deletion, only available via tool set Storage Location A8 Bush Mechanical tool NOTE: (Slip bush) For fitting steering angle sensor on steering column Storage Location A3 SI n ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2021 Copyright www.bmwx3tech.com - 0.0043