Screw Minimum set: Mechanical tools Mechanical tool
NOTE: Ring bolt for removing and installing the E-machine from the transmission bell housing.
SI number
01 26 11 (763)
Screw Minimum set: Mechanical tools AM
NOTE: (Connection) Banjo bolt M20x1.5 - M18x1.5/For checking the converter pressure/transmission: 3 HP 12 Deletion, only available via tool set
Storage Location
C3
Screw AM
NOTE: (Retaining screws (2 x)) Transmission: 3 HP 12
Storage Location
X6
Screw AM
NOTE: (Retaining screws (2 x)) for torque converter/transmission: 4 HP 24, A4S 270R, A4S 310R
Storage Location
X6
Replaced by: 83300495498
NOTE: (Adjusting screw) Discontinuation and replaced by 23 4 050 (0 495 498)
NOTE: (Mounting bolt (2 pieces))
Storage Location
X6
Screw Minimum set: Mechanical tools AM
NOTE: (Screw) M18x1.5/For closing the engine oil feed pipe when checking the converter pressure/transmission: 3 HP 20 Deletion, only available via tool set
Storage Location
C3
Screw Minimum set: Mechanical tools AM
NOTE: Discontinued, can only be ordered using complete tool
SI number
01 02 07 (334)
BMW X3 Service & Repair Manual > Engine wiring loom: Replacing section of wiring harness for injectors (N47 D20 O1)
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE
(ESD PROTECTION) .
Necessary preliminary work:
Read out the fault memory of the DDE control unit.
Switch off ignition.
Disconnect BATTERY EARTH LEAD .
Remove INTAKE FILTER HOUSING .
Remove rear aco ...