BMW X3 Service & Repair Manual: Gap dimensions, body

The dimensions specified in this information are applicable at an object temperature of 20 ºC. The aim of adjustment is to achieve a uniform gap.

Symmetry of the gaps between left and right sides of the vehicle has top priority.

The door gaps must not deviate between the front and rear door gap by more than 1.0 mm.

No gap dimension are specified for components which cannot be adjusted.

Dimensions in mm

Body+and+Frame

Body+and+Frame

  1. Panel, bumper, front
  2. Headlight

Body+and+Frame

Body+and+Frame

Body+and+Frame

Body+and+Frame

  1. Rear door
  2. Rear side walls

Body+and+Frame

    Frame alignment control dimensions, body
    Dimensions in mm. Measurement tolerances: ≤ 1000 mm Â+- 1.5 mm ≥ 1000 mm Â+- 2.5 mm The control points shown serve to check the body a ...

    General instructions on paintwork
    The marked area serves as reference value for paintwork. This area may differ from the illustration for technical painting reasons. Touching-up ...

    Other materials:

    BMW X3 Service & Repair Manual > Heater with operation: Removing and installing (replacing) control panel for heating and air conditioning system
    Necessary preliminary tasks: Remove RADIO AND A/C CONTROL PANEL The following operation describes the replacement. Disconnect plug connection (1). Release retainers (3) on air conditioning control panel (2) by pressing the retaining tabs (3) inward with a suitable tool. At the same ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2020 Copyright www.bmwx3tech.com - 0.0057