BMW X3 Service & Repair Manual: Releasing bonded folded seam connections

BMW X3 Service & Repair Manual / Body and Frame / Body repair instructions / Releasing bonded folded seam connections

Body+and+Frame

  • Remove area (1) of bead edge on wheel arch bend with a one-hand angle grinder and rough grinding wheel.
  • Heat area (2) with hot air blower.

CAUTION: Extract vapors and gases.

  • Release connection flange with chisel.
  • Grind adhesive residue (4) off wheel arch connection flange.

CAUTION: Wear a grinding dust mask.

  • Remove remnants of sealing material in area (3).
    Reinforcement plate with stud bolt (bonded)
    In the case of partial replacement, a body component is cut at the point described in the repair instructions. A reinforcement plate is bonded in ...

    Repair methods, repair stages 1
    All work as part of which screwed body components must be replaced. Repair techniques REPAIRING THREADS Repair stage 1a Blind rivet . ...

    Other materials:

    BMW X3 Service & Repair Manual > Transmission: Extension housing, bearings, seal
    REPLACING OUTPUT FLANGE RADIAL SHAFT SEAL (GA8HP45Z) (AWD) Special tools required: 23 0 490 23 3 220 IMPORTANT: After completion of repair work, check TRANSMISSION OIL LEVEL . Use only the approved TRANSMISSION OIL . Failure to comply with this requirement will result in serious dam ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2021 Copyright www.bmwx3tech.com - 0.0082