BMW X3 Service & Repair Manual: Replacing the carrier support before the wheel arch on the right

BMW X3 Service & Repair Manual / Body and Frame / Support members / Replacing the carrier support before the wheel arch on the right

Note the specific procedure with regard to the vehicle identification number (if necessary, order new body part with the vehicle identification number).

Operation is identical to REPLACING CARRIER SUPPORT IN FRONT OF WHEEL ARCH ON LEFT.

STRIPPING OPERATIONS - REPLACING CARRIER SUPPORT IN FRONT OF LEFT WHEEL ARCH

NOTE: Owing to the different engine variants and equipment specifications, not all the components are taken into consideration.

The following list basically represents the removal sequence.

  • Disconnect battery earth lead (61 20 900 )
  • Remove bumper trim (51 11 156 )
  • Remove front panel (41 33 039)
  • Remove front underbody protection assembly (51 47 490 )
  • Remove front side panel (41 35 081)
  • Remove front wheel arch cover (front section) (51 71 038 )
  • Remove intake silencer housing (INTAKE SILENCER )
  • Partially release left wiring harness
    Replacing the carrier support before the wheel arch on the left
    Read contents of BODY, GENERAL. Follow procedure for REPAIR STAGE 2. STRIP DOWN vehicle. The following new body parts are required (refer to OV ...

    Luggage compartment floor
    ...

    Other materials:

    BMW X3 Service & Repair Manual > Front axle: Laser
    Laser Minimum set: Mechanical tools AM LEVER Lever AM NOTE: Lever in connection with hydraulic cylinder (hydraulic actuator), (81 64 2 156 246), for removal and installation of wheel bearings, propeller shafts and drive flanges. SI number 08 06 09 (544) LOCATING FIXTURE Locati ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2020 Copyright www.bmwx3tech.com - 0.0074