Necessary preliminary tasks:
After completing repair work: BLEED BRAKE SYSTEM.
Press brake pedal down to floor and secure with pedal support.
NOTE: The pedal support may only be released when the brake lines are reconnected.
This prevents brake fluid from emerging from the expansion tank and air from entering the system when the brake lines are opened.
Release retaining screw (1).
If necessary, grip at knurling (2).
IMPORTANT: Never twist brake hose when installing it and avoid all contact with parts attached rigidly to the body.
If necessary, remove brake pad wear sensor.
Lever out retaining spring (1) in direction of arrow towards rear.
Installation note: Place retaining spring (1) first at top and bottom of brake caliper and then allow to engage in recess (2) of brake caliper housing.
Remove plastic plugs (1).
Unscrew guide bolts (1).
Withdraw brake caliper backwards.
Installation note:
Only clean guide bolts; do not grease.
Check threads.
Replace all guide screws which are not in perfect condition.
IMPORTANT: Mark any worn brake pads.
Remove brake pads in direction of arrow.
In the event of one-sided brake pad wear, do not change brake pads round.
If necessary, clean brake caliper and brake pad.
Equipment specification, high-speed brake system.
IMPORTANT: Mark any worn brake pads.
Remove brake pads in direction of arrow.
In the event of one-sided brake pad wear, do not change brake pads round.
If necessary, clean brake caliper and brake pad.
BMW X3 Service & Repair Manual > Control arms and struts: Replacing rubber mount for trailing arm in wheel carrier
Special tools required:
0 496 553
0 496 554
2 293 777
2 293 768
2 293 772
Necessary preliminary tasks:
Remove REAR WHEEL .
Remove TRAILING ARM.
Remove CAMBER ARM FROM WHEEL CARRIER.
Withdrawing rubber mount:
Pull out rubber mount with special tools 0 496 553, 0 496 554, ...