BMW X3 Service & Repair Manual: Removing and installing/replacing vent valve for brake caliper

BMW X3 Service & Repair Manual / Brakes / Front brakes / Removing and installing/replacing vent valve for brake caliper

Necessary preliminary work:

  • Raise vehicle.

Removal:

Press brake pedal down to floor and secure with pedal support.

NOTE: The pedal support may only be released when the brake lines are reconnected.

This prevents brake fluid from emerging from the expansion tank and air from entering the system when the brake lines are opened.

Brakes

Remove dust cap (1).

Brakes

Remove vent valve (1).

IMPORTANT: Collect escaping brake fluid in a suitable collecting vessel.

Brakes

Installation:

IMPORTANT: The bore hole must be free of contamination!

Install vent valve (1).

Brakes

Mount dust cap (1).

Brakes

Remove pedal support.

Brakes

Required follow-up work:

  • Bleed brake system.
    Removing and installing/replacing left or right front brake caliper
    Necessary preliminary tasks: REMOVE WHEEL . Read and comply with GENERAL INFORMATION. After completing repair work: BLEED BRAKE SYSTEM. Pr ...

    Replacing front left or right brake anchor plate/guard plate
    Necessary preliminary work: Remove front BRAKE DISC. Release screws (1) and remove brake guard plate (2). ...

    Other materials:

    BMW X3 Service & Repair Manual > Parking brake: Removing and installing/replacing emf actuator
    Necessary preliminary tasks: Release parking brake. Switch off ignition. IMPORTANT: Switch off ignition at least 30 s before disconnecting the plug connection! After installation, observe the following: switch on ignition and, using parking brake operating element, open parking ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2020 Copyright www.bmwx3tech.com - 0.0082