BMW X3 Service & Repair Manual: Holding sleeve

Holding sleeve Mechanical tool

NOTE: (Assembly sleeve) with a diameter of 22 mm to insert piston and sleeve into the tandem brake master cylinder

Brakes

NOTE: (Assembly sleeve) For inserting the piston with sleeve into the tandem brake master cylinder, dual-circuit brake system

Brakes

JOINT

Joint Mechanical tool

Replaced by: 83300493705

NOTE: With hexagon socket WAF 7 mm, 3/8" connection for removing and installing the guide bolts on the rear brake calliper Replaced by 34 1 080. (0 493 705)

Storage Location

A7

SI number

01 05 90 (207)

Brakes

Nut

Nut Minimum set: Mechanical tools AM

NOTE: Nut is an integral part of resetter 83 30 2 320 871 with identification A.

SI number

01 11 12 (807)

Brakes

OPERATING INSTRUCTIONS

Operating instructions AM

Brakes

    Gauge
    Gauge Mechanical tool NOTE: For adjusting the acceleration sensors - all-wheel drive vehicles Storage Location Z9 Gauge Minimum set: Mech ...

    Pin wrench
    Pin wrench Minimum set: Mechanical tools Mechanical tool NOTE: To reset the automatic readjustment of the electrical parking brake (rear disc ...

    Other materials:

    BMW X3 Service & Repair Manual > Front axle: Mandrel
    Mandrel Mechanical tool NOTE: (drift) For output shaft radial sealing ring in the front axle differential NOTE: (Drift) For driving the radial shaft seals into the front wheel hubs and the input flange of the rear axle differential Mandrel Mechanical tool NOTE: (drift ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2021 Copyright www.bmwx3tech.com - 0.0072