BMW X3 Service & Repair Manual: Spindle
Spindle Minimum set: Mechanical tools AM
NOTE: Spindle is an integral part of resetter 83 30 2 320 871 with identification B.
SI number
01 11 12 (807)
TENSIONING STRAP
Tensioning strap Mechanical tool
NOTE: To change the knock sensor controller on the H31 brake system
Storage Location
Z10
Z9
TESTER
Tester AM
NOTE: (Tester) Tester for Anti-lock Brake System with Automatic Stability Control
Storage Location
K 105
SI number
02 05 92 (534)
Consisting of:
1 = Tester
NOTE: (Tester) Control unit test
2 = Adapter
NOTE: (Test adapter 35/35- pin)
3 = Adapter
NOTE: (Test adapter 35/55- pin)
4 = Adapter cable
NOTE: (Adapter cable) Connecting line diagnosis
5 = Disk
NOTE: (Disk) Test disk 3 1/2"
6 = Case
NOTE: Not for individual order
9 = Operating instructions
NOTE: (Tester) Control unit test
Storage Location
K 105
Shaped part
Shaped part AM
NOTE: (Shaped parts)
SHELL
Shell Mechanical tool
NOTE:
(bearing shells) 2 pieces For the pressure accumulator of the ...
Tool
Tool Mechanical tool
NOTE: (Pressing-in tool) for pressing in the shielding caps on both sides in the fixed
calliper shafts - brake piston diame ...
Other materials:
BMW X3 Service & Repair Manual > Support members: Replace entrance for front left door
Observe procedure for REPAIR STAGE 3.
Read contents of BODY, GENERAL.
Following new body parts are required (refer to OVERVIEW OF CONSUMABLES):
(1) A-pillar with entrance
Mark severance cuts in accordance with specified dimensions and cut.
IMPORTANT: Cut outer panel only for follo ...