BMW X3 Service & Repair Manual: Front propeller shaft

REMOVING AND INSTALLING FRONT PROPELLER SHAFT

IMPORTANT: Do not move vehicle under its own drive power once propeller shaft has been removed.

IMPORTANT: On four-wheel drive vehicles with defective, non-engaging drive, it is imperative that the following information is taken account of.

Necessary preliminary tasks:

  • Remove underbody protection at front and rear .
  • Remove REINFORCEMENT PLATE .

Release screws.

Installation note: Replace ZNS bolts.

Slide propeller shaft towards rear and remove.

Driveline+Axles

Installation note: Slide propeller shaft fully towards rear.

Sealing cup (1) must snap audibly into place and rest entirely on dust guard (2).

Driveline+Axles

    Replacing grooved ball bearing in propeller shaft center bearing
    Special tools required: 23 1 160 33 3 202 33 3 203 Necessary preliminary tasks: Replace PROPELLER SHAFT CENTER BEARING Press grooved ...

    Propeller shaft
    ...

    Other materials:

    BMW X3 Service & Repair Manual > Note, overview components climate control: Safety information for working on vehicles with automatic engine start-stop function (msa)
    WARNING: If the engine hood/bonnet contact is pulled upwards (workshop mode), the information "switch closed" is output. The automatic engine start-stop function is active. An automatic engine start is possible. Observe safety precautions when working on MSA vehicles. Before carrying out ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2021 Copyright www.bmwx3tech.com - 0.004