BMW X3 Service & Repair Manual: Mobile table lift

WARNING: Danger of injury! Before beginning work, position table lift with the lower frame securely on the floor.

Danger area around mechanism below platform.

  • Do not reach into or step into the danger area.
  • Note permissible bearing capacity of table lift.
  • Mount load centrally (danger of tipping) and secure against shifting.

Follow the operating instructions from the equipment manufacturer.

The mobile table lift is used for collision repairs and when removing large engines.

Adaptations for mounting front axle with engine and transmission.



Release star knob screw on working plate (B) of table lift; the working surface (B) can be extended by approx. 310 mm.

Release all push-pull clamps and the working plates can be shifted by approx. 20 mm.

Working plate (A and B) can be raised and lowered by 3º on the long side and by 5º on the transverse side.

Working plate (A and B) is subdivided by a coordinate system and a possible installation position is recommended in the respective repair manual.


IMPORTANT: Follow the operating instructions from the equipment manufacturer.

    Lifting the vehicle using a vehicle hoist
    WARNING: Danger to life! Read and follow operating instructions for vehicle hoist. Do not exceed approved load-carrying capacity and load dis ...

    Notes on repairing threads (A)
    IMPORTANT: Install Helicoil thread inserts so that they are flush with the original thread! NOTE: Damaged threads may be repaired with Helicoil t ...

    Other materials:

    BMW X3 Service & Repair Manual > Parking brake: Removing and installing control unit for parking brake
    IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection). Necessary preliminary work: Raise luggage compartment floor trim. Disconnect plug connection (1) and remove control unit (2). Replacement: Carry out programming/encoding of contr ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2020 Copyright - 0.0072