BMW X3 Service & Repair Manual: Safety information for working on vehicles with automatic engine start-stop function (msa)

BMW X3 Service & Repair Manual / Driveline+Axles / Front axle repair instructions / Safety information for working on vehicles with automatic engine start-stop function (msa)

WARNING: If the engine hood/bonnet contact is pulled upwards (workshop mode), the information "switch closed" is output. The automatic engine start-stop function is active.

An automatic engine start is possible.

Observe safety precautions when working on MSA vehicles.

Before carrying out practical work on the engine, always ensure that the MSA functionality is deactivated so as to prevent automatic engine starting while work is being carried out in the engine compartment.

MSA function is deactivated by:

  • Deactivate MSA by means of button (1) in passenger compartment
  • Open seat belt buckle and driver's door

Driveline+Axles

Open engine bonnet/hood and ensure that engine hood/bonnet contact is not in workshop mode

  • Workshop mode A = 10 mm
  • Basic setting (engine hood/bonnet open) B = 7 mm

To make sure that the engine hood/bonnet contact is at the basic setting, if necessary press the hood/bonnet contact up to the limit position before starting work and slowly release.

Driveline+Axles

    Risk of injury if oil comes into contact with eyes and skin
    Danger of injury! Contact with eyes or skin may result in injury! Possible symptoms are: Impaired sight Irritation of the eyes Reddening of ...

    Safety instructions for handling oil
    WARNING: DANGER OF POISONING if oil is ingested/absorbed through the skin! RISK OF INJURY if oil comes into contact with eyes and skin! Rec ...

    Other materials:

    BMW X3 Service & Repair Manual > Final drive mounting: Replace the rubber mounts for the front of the rear axle final drive suspension
    Special tools required: 33 5 200 33 5 206 33 5 166 33 5 163 33 5 162 33 5 161 33 4 466 33 4 465 33 5 105 33 5 164 33 5 165 Necessary preliminary tasks: Remove exhaust system . Remove PROPELLER SHAFT AT FINAL DRIVE . Position special tool 33 5 200 on workshop jack ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2020 Copyright www.bmwx3tech.com - 0.0076