Necessary preliminary work:
IMPORTANT: Check the rubber gaiter and circlip for damage! When removing and installing the trailing link, check the seat of the circlip seal between the trailing link and the wheel control joint and replace the wheel control joint if needed!
Release screw (1).
Remove guide joint from swivel bearing.
Installation note: Rework thread in swivel bearing.
Keep guide joint and bore hole in swivel bearing clean and free from oil and grease.
Replace microencapsulated screw.
BMW X3 Owners Manual > Maintenance: Socket for OBD Onboard
Diagnosis
Note
Socket for Onboard Diagnosis
The socket for onboard diagnostics may
only be used by the service center or a workshop
that operates in accordance with the
specifications of the vehicle manufacturer with
correspondingly trained personnel and other
authorized persons. Otherwise, use may res ...