BMW X3 Service & Repair Manual: Bush

Bush AM

NOTE: For installing the rubber mount in the front axle support - series: E1

Driveline+Axles

NOTE: (Bush) For installing the rubber mount in the front axle support and thrust piece, for removing and installing the rubber mount in the wishbones

Driveline+Axles

Bush Mechanical tool

NOTE: (impact bush) For fitting the radial sealing ring to the drive flange of the front axle differential

Storage Location

X7

SI number

01 04 93 (664)

Driveline+Axles

Bush AM

NOTE: (Bush) Deletion, only available via tool set

Driveline+Axles

NOTE: (Bush) For removing the rubber mount from the front axle support, for removing and installing the rubber mount in the wishbones and for press-fitting the taper roller bearing of the rear axle differential housing

Driveline+Axles

NOTE: (Slip bush) For installing the rubber mount in the front axle support

Driveline+Axles

NOTE: (Pressure bush)

Driveline+Axles

NOTE: (Threaded bush)

Driveline+Axles

CLIP

Clip Mechanical tool

NOTE: (mounting fixture) For the front axle differential

Driveline+Axles

    Bolt
    Bolt AM Replaced by: 83300492053 NOTE: Replaced by 32 3 090. (0 492 053) Bolt Mechanical tool NOTE: (drive pin) For radial gears in t ...

    Device
    Device AM NOTE: For drawing spring strut into swivel bearing seat. Storage Location B72 SI number 01 13 07 (387) Consisting of: 1. Basi ...

    Other materials:

    BMW X3 Service & Repair Manual > Starter with mounting: Replacing solenoid switch
    Turn off ignition. Remove starter motor. Release nut (1). Remove cable lug (2). CAUTION: Do not turn cable lug (2) while tightening down - risk of short circuit to starter motor housing. Release screws (1). Remove solenoid switch (1) and spring (2). Unhook pin (3). Install ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2020 Copyright www.bmwx3tech.com - 0.0063