BMW X3 Service & Repair Manual: Laser

Laser Minimum set: Mechanical tools AM

Driveline+Axles

LEVER

Lever AM

NOTE: Lever in connection with hydraulic cylinder (hydraulic actuator), (81 64 2 156 246), for removal and installation of wheel bearings, propeller shafts and drive flanges.

SI number

08 06 09 (544)

Driveline+Axles

LOCATING FIXTURE

Locating fixture Minimum set: Mechanical tools AM

NOTE: For attaching and aligning the laser on the spring strut.

Driveline+Axles

    Insert
    Insert Mechanical tool NOTE: Protective insert As of 08/2011, replaces the previous special tool number 31 3 365 SI number 01 16 11 (738) ...

    Mandrel
    Mandrel Mechanical tool NOTE: (drift) For output shaft radial sealing ring in the front axle differential NOTE: (Drift) For driving ...

    Other materials:

    BMW X3 Service & Repair Manual > Electronic switching or control units: Replacing suction pressure sensor on intake plenum (N55)
    Necessary preliminary work: Read out the fault memory of the DME control unit. Switch off ignition. Remove INTAKE FILTER HOUSING . Release connector (1) and remove. Release screws and pull suction pressure sensor (2) out of intake plenum. Installation note: Check sealing ring for d ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2021 Copyright www.bmwx3tech.com - 0.008