Synchronising key AM
NOTE: For wheel bearing race, outer
Synchronising key AM
NOTE: (Thrust piece) For removing
Synchronising key Mechanical tool
NOTE: For pressing the rubber mount out of the connecting pipe on the engine support
Storage Location
Y10
SI number
01 04 86 (566)
Synchronising key Minimum set: Mechanical tools AM
NOTE: Series: E30, E36, E46, E85
Storage Location
A7
Synchronising key Minimum set: Mechanical tools AM
NOTE: (Synchronizing key, diameter 79 mm) For mounting the rubber mount on the wishbone, series: E46
Storage Location
A7
Synchronising key Mechanical tool
NOTE: For pressing out the front wheel bearing
Storage Location
Y5
Synchronising key AM
Replaced by: 83300492053
NOTE: Discontinuation and replaced by 33 4 200 (0 492 053)
Synchronising key AM
NOTE: For removing and installing the rubber mount in the front axle support - series: E12
Synchronising key AM
NOTE: For installing
Synchronising key AM
NOTE: For removing
NOTE: For wheel bearing race, inner
Synchronising key Mechanical tool
NOTE: For pressing the roller bearing onto the differential housing
BMW X3 Service & Repair Manual > Driveline+Axles: Approved final drive oils for front and rear axle final drives with and
without limited slip or viscous coupling
2.0 APPROVED FINAL DRIVE OILS FOR FRONT AND REAR AXLE FINAL
DRIVES WITH AND WITHOUT LIMITED SLIP OR VISCOUS COUPLING
LIMITED SLIP DIFFERENTIALS
With the introduction of the Z3 roadster a new synthetic final drive oil for all vehicles with a multi-plate
limited-slip differential has been releas ...