BMW X3 Service & Repair Manual: Removing and installing complete rear axle support

BMW X3 Service & Repair Manual / Driveline+Axles / Rear sub-frame / Removing and installing complete rear axle support

WARNING: Danger of injury! Failure to comply with the following instructions may result in the vehicle slipping off the vehicle hoist and critically injuring other persons.

Load the luggage compartment with a minimum of 100 kg before lowering/removing the rear axle support.

When supporting components, make sure that:

  • the vehicle can no longer be raised or lowered
  • the vehicle does not lift off the locating plates on the vehicle hoist.

IMPORTANT: Observe SAFETY INFORMATION for raising the vehicle.

In order to avoid damage to vehicle hoist, perform weight compensation on vehicle.

Necessary preliminary tasks:

  • Remove PULSE GENERATOR .

NOTE: The subsequent procedure is described in 33 31 011 Replacing rear axle support.

IMPORTANT: Prior to installation, check sensor head and cable on pulse sensor and renew if necessary.

    Lowering/raising rear axle support
    Special tools required: 31 5 251 00 2 030 31 5 255 31 5 253 33 5 206 WARNING: Danger of injury! Failure to comply with the followi ...

    Replacing rear axle support
    WARNING: Danger of injury! Failure to comply with the following instructions may result in the vehicle slipping off the vehicle hoist and criti ...

    Other materials:

    BMW X3 Service & Repair Manual > Luggage compartment floor: Stripping operations - replacing luggage compartment floor, middle (tail panel removed)
    NOTE: Owing to the different engine variants and equipment specifications, not all the components are taken into consideration. The following list basically represents the removal sequence. Remove positive battery cable (61 12 002 ) Remove exhaust system. Remove exhaust syst ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2021 Copyright www.bmwx3tech.com - 0.0074