Extractor AM
NOTE: (Rillex extractor) For bevel pinion and differential case (rear diff)/for installation of camshaft sprocket on crankshaft (M70)/for removing bearing inner race from drive flange (E36, E46)
Storage Location
Y4
Z4
Consisting of:
1 = Connector
NOTE: (Basic body) For transmissions S5D 260Z, S5D 310Z and S5D 320Z;Discontinued, only available via complete tool
2 = Washer
NOTE: (Disc) Replaced by 33 1 311. (0 492 107)
3 = Washer
NOTE: (Disc) Replaced by 33 1 311. (0 492 107)
4 = Washer
NOTE: (Disc) Replaced by 33 1 311. (0 492 107)
5 = Synchronising key
NOTE: (Thrust piece (old)) Discontinued, only available via complete tool
6 = Synchronising key
7 = Synchronising key
NOTE: Not available individually. Only via complete tool set
8 = Synchronising key
9 = Synchronising key
NOTE: For rear axle differential and for installing the camshaft sprocket on the crankshaft (M70) Discontinued, only available via complete tool
1 = Washer
NOTE: (Disc) Discontinued, only available via complete tool
2 = Synchronising key
NOTE: For pulling the bearing inner race off the drive flange - Series: E36/5 Discontinued, only available via complete tool
FITTING AID
Fitting aid Mechanical tool
NOTE: (Installation spoon) For installing the gaiter on the output shafts with sliding joints
BMW X3 Owners Manual > Refueling: Fuel lid
Opening
1. Briefly press the rear edge of the fuel filler
flap.
2. Turn the tank lid counterclockwise.
3. Place the tank lid in the bracket attached to
the fuel filler flap.
Closing
1. Fit the lid and turn it clockwise until you
clearly hear a click.
2. Close the fuel filler flap.
...