BMW X3 Service & Repair Manual: Maintenance service reminder reset - procedure 5

BMW X3 Service & Repair Manual / DTC / Maintenance service reminder / Maintenance service reminder reset - procedure 5

NOTE: On some models an appropriate scan tool may be used to reset CBS service schedules. By using suitable diagnostic equipment connected to the vehicle diagnostic connector it is possible to reset CBS service schedules at any time.

By selecting the `CBS' option, the diagnostic equipment will gather information regarding the current state of CBS items from their relevant modules on the CAN network. See MAINTENANCE SERVICE REMINDER RESET - PROCEDURE 6.

On-the-vehicle service operations can be reset at the instrument panel.

NOTE: A reset is only possible in the car if:

  • There is no Check Control message
  • Availability of the service job is under 90%
  • On-board date must be correctly set

NOTE: Resetting of a service job must always be carried out after a maintenance measure has been completed.

IMPORTANT: If engine oil and vehicle check are reset at the same time, always reset engine oil first.

1. Switch the ignition on.

2. Press the odometer reset button (1) until the 1st service job appears in the display (2) - 6 to 10 seconds.

3. Bring up the next item by briefly pressing the button again.

4. Select the desired service job.

5. If a reset is possible, this is displayed in the instrument panel as "Reset executable".

6. Start the reset by pressing the button for 3 seconds.

7. Confirm text message "Execute reset?" by pressing the button for 3 seconds again.

8. The status of the reset is indicated in the display by a progress bar and in text as "Reset running".

9. The reset is confirmed after completion as "Reset successful".

DTC

DTC

DTC

DTC

DTC

    Maintenance service reminder reset - procedure 4
    NOTE: On some models an appropriate scan tool may be used to reset CBS service schedules. By using suitable diagnostic equipment connected to the v ...

    Maintenance service reminder reset - procedure 6
    CBS Reset Using BMW Diagnosis System IMPORTANT: Although the CBS maintenance jobs can be reset using in-car controls, it is recommended that t ...

    Other materials:

    BMW X3 Service & Repair Manual > Heater with operation: Replacing controller for heating and air conditioning system blower
    Necessary preliminary work: Remove TRIM FOR INSTRUMENT PANEL, BOTTOM LEFT Removal: Release screws (1). Unlock and disconnect connector (2). Remove controller (3) downwards. Installation: Position controller (3) correctly. Tighten down the screws (1). Connect connector (2). R ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2020 Copyright www.bmwx3tech.com - 0.0063