BMW X3 Service & Repair Manual: Replacing pulse sensor on intake camshaft (N20)

BMW X3 Service & Repair Manual / Electrical / Electronic switching or control units / Replacing pulse sensor on intake camshaft (N20)

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks:

  • Read out the fault memory of the DME control unit.
  • Switch off ignition.

Unlock connector (1) and remove.

Release screw.

Remove pulse sensor (2).

Check gasket, renew damaged gasket.

Electrical

NOTE: Check stored fault message.

Delete fault memory.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary work:

  • Read out the fault memory of the DME control unit.
  • Switch off ignition.
  • Remove ACOUSTIC COVER

Release connector (1) and remove.

Release screw.

Installation note:

Replace screw.

Remove pulse sensor (2).

Installation note:

Replace sealing ring.

Electrical

NOTE: Check stored fault messages.

Delete fault memory.

    Replacing pulse sensor on exhaust camshaft (N55)
    IMPORTANT: Aluminum screws/bolts must be replaced each time they are released . Aluminum screws/bolts are permitted with and without color co ...

    Replacing pulse sensor on intake camshaft (N55)
    IMPORTANT: Aluminum screws/bolts must be replaced each time they are released . Aluminum screws/bolts are permitted with and without color co ...

    Other materials:

    BMW X3 Service & Repair Manual > Troubleshooting: Notes on handling wiring harnesses and cables
    The following applies in general: To avoid damage, observe the following instructions: Avoid compressive and tensile loads To ensure professional repairs, perform repair work only with BMW-approved or recommended special tools and spare parts Make sure cables are laid without kinks or abr ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2021 Copyright www.bmwx3tech.com - 0.0086