BMW X3 Service & Repair Manual: Replacing pulse sensor on intake camshaft (N55)

BMW X3 Service & Repair Manual / Electrical / Electronic switching or control units / Replacing pulse sensor on intake camshaft (N55)

IMPORTANT: Aluminum screws/bolts must be replaced each time they are released .

Aluminum screws/bolts are permitted with and without color coding (blue).

For reliable identification: Jointing torque and angle of rotation must be observed without fail (risk of damage) .

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Necessary preliminary work:

  • Read out the fault memory of the DME control unit.
  • Switch off ignition.
  • Remove FAN COWL .

Release connector (1) and remove.

Release screw.

Remove pulse sensor (2).

Electrical

NOTE: Check stored fault message.

Delete fault memory.

    Replacing pulse sensor on intake camshaft (N20)
    IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) . Necessary preliminary tasks: Read ...

    Replacing suction pressure sensor on intake plenum (N20, N26)
    Necessary preliminary tasks: Read out the fault memory of the DME control unit. Switch off ignition. Partially undo the acoustic cover. Unl ...

    Other materials:

    BMW X3 Service & Repair Manual > Stabilizer bar: Removing and installing/replacing rear anti-roll bar
    Necessary preliminary work: Remove BOTH ANTI-ROLL BAR LINKS FROM ANTI-ROLL BAR. Lower REAR AXLE SUPPORT. NOTE: To simplify the graphic, anti-roll bar removal is shown on the removed rear axle. Release screws (1). Remove both RUBBER MOUNTS FROM ANTI-ROLL BAR. Turn anti-roll bar (2) an ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2021 Copyright www.bmwx3tech.com - 0.0079