BMW X3 Service & Repair Manual: Removing and installing/replacing servodrive for defrosting flap (right)

BMW X3 Service & Repair Manual / HVAC / Heater with operation / Removing and installing/replacing servodrive for defrosting flap (right)

Necessary preliminary work:

  • Remove SUPPORT FOR DASHBOARD

Release screws (1).

Remove actuator drive (2).

Release plug connection (3) and disconnect.

HVAC

IMPORTANT: Servomotors must be readdressed in the event of replacement! Addressing can only be carried out with the BMW diagnosis system.

Service functions:

  • Body
  • Heating and air conditioning function
  • Flap motors
  • Readdress flap motors
    Removing and installing/replacing servodrive for blending flap (right)
    Necessary preliminary work: Remove RIGHT GLOVE BOX WITH HOUSING Release screws (1). Detach actuator drive for air mix flap (2). Unlock as ...

    Removing and installing/replacing ventilation temperature sensor
    Necessary preliminary work: Remove DECORATIVE STRIP ON DASHBOARD IN MIDDLE Pull temperature sensor (1) out of retaining lug (2). Installation ...

    Other materials:

    BMW X3 Service & Repair Manual > Body special tools: Tool set
    Tool set Mechanical tool NOTE: Tool set for M5 threaded insert SI number 01 02 14 (069) Tool set Mechanical tool SI number 01 02 14 (069) ENGINE COMPARTMENT LID TIGHTENING TORQUE SPECIFICATION - ENGINE COMPARTMENT LID FRONT DOORS TIGHTENING TORQUE SPECIFICATION - FRONT DOORS ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2021 Copyright www.bmwx3tech.com - 0.0045