Bush AM
NOTE: For installing the rubber mount in the front axle support - series: E12
Bush AM
NOTE: (Bush) For installing the rubber mount in the front axle support and thrust piece, for removing and installing the rubber mount in the wishbones
Bush Mechanical tool
NOTE: (impact bush) For fitting the radial sealing ring to the drive flange of the front axle differential
Storage Location
X7
SI number
01 04 93 (664)
Bush AM
NOTE: (Bush) Deletion, only available via tool set
Bush AM
NOTE: (Bush) For removing the rubber mount from the front axle support, for removing and installing the rubber mount in the wishbones and for press-fitting the taper roller bearing of the rear axle differential housing
NOTE: (Slip bush) For installing the rubber mount in the front axle support
NOTE: (Pressure bush)
NOTE: (Threaded bush)
CLIP
Clip Mechanical tool
NOTE: (mounting fixture) For the front axle differential
BMW X3 Service & Repair Manual > Heater with operation: Removing and installing/replacing heater/air conditioner blower
Necessary preliminary work:
Remove TRIM FOR INSTRUMENT PANEL AT BOTTOM RIGHT
Detach right footwell heating duct (1) in direction of arrow from retaining lug (3) and lay to one side slightly.
Installation note:
Make sure clip (2) is correctly seated.
Unfasten plug connection (1) and disco ...