BMW X3 (F25) Service & Repair Manual: Stabilizer bar
- Removing and installing/replacing rear anti-roll bar
- Replacing both rubber mounts for anti-roll bar mounting
Removing and installing/replacing rear anti-roll bar
Necessary preliminary work:
- Remove BOTH ANTI-ROLL BAR LINKS FROM ANTI-ROLL BAR.
- Lower REAR AXLE SUPPORT.
NOTE: To simplify the graphic, anti-roll bar removal is shown on the removed rear axle.
Release screws (1).
Remove both RUBBER MOUNTS FROM ANTI-ROLL BAR.
Turn anti-roll bar (2) and remove from the side.
Installation note:
Check both rubber mounts for damage and replace if necessary.
Keep retaining bracket, rubber mount and stabilizer clean and free from oil and grease.
REPLACING ANTI-ROLL BAR LINK FOR ANTI-ROLL BAR ON LEFT OR RIGHT
Release nuts (1); if necessary, grip at inner Torx socket.
Release screw (2).
Remove anti-roll bar link (3).
Installation note: Replace self-locking nut and screw.
Replacing both rubber mounts for anti-roll bar mounting
Necessary preliminary work:
- Remove REAR WHEELS .
Release screws (1).
Pull off retaining bracket (2), open rubber mount (3) at slot and remove.
Installation note:
Keep retaining bracket (2), rubber mount (3) and anti-roll bar clean and free from oil and grease.
Clean rear anti-roll bar on both sides.
Position rubber mount on rear anti-roll bar.
Mount retaining bracket (2) on rubber mount (3).
Push rubber mount with retaining bracket on rear anti-roll bar to installation position and screw tight.
Springs with suspension
REMOVING AND INSTALLING/REPLACING REAR LEFT OR RIGHT COIL SPRING
Installation note:
1. All screws, nuts, bolts and hose clamps removed during the ...
Rear axle
...
Other materials:
BMW X3 (F25) Service & Repair Manual > HVAC: Operating fluids - air conditioning and heating
1.0 REFRIGERANT R134A
In order to fulfil the environmental compatibility requirements of BMW products and to reduce the ozone
pollution of the earth's atmosphere caused by refrigerants needed for heating and air conditioning systems, from
April 1991 on and starting with the model E32/M30 and th ...