BMW X3 Service & Repair Manual: Installing exchange transmission (GA8HP45Z) (N52, N55, N47)

BMW X3 Service & Repair Manual / Transmission / Transmission in general / Installing exchange transmission (GA8HP45Z) (N52, N55, N47)

IMPORTANT:

  • Do not let skin come in contact with transmission oil and do not inhale transmission oil vapors.
  • Wear protective gloves.
  • Ensure adequate ventilation

Drain automatic transmission fluid at oil drain plug.

IMPORTANT: After completion of work, program control transmission control unit.

Recycling:

Catch and dispose of escaping transmission oil.

Observe country-specific waste disposal regulations.

IMPORTANT:

  • Before installing exchange transmission, always flush TRANSMISSION OIL COOLER TOGETHER WITH LINES .
  • After completion of work, CHECK TRANSMISSION OIL LEVEL .
  • Use only approved TRANSMISSION OIL .

    Failure to comply with this requirement will result in serious damage to the automatic transmission Exchange transmissions come filled with oil

Necessary preliminary tasks:

  • Remove automatic transmission .
  • Remove transfer box .

Modify transportation retainers.

Convert all cable clips.

Convert all seal plugs.

Convert protective cap on output shaft.

IMPORTANT: After removing transportation retainer, secure torque converter against slipping out.

Transmission identification:

  • On type plate

Transmission

    Checking/topping up oil level in automatic transmission (GA8HP45Z, GA8HP50Z, GA8HP90Z)
    IMPORTANT: Do not let skin come in contact with transmission oil and do not inhale fuel vapors. Wear protective gloves. Ensure adeq ...

    Installing exchange transmission (GA8HP45Z) (N20)
    IMPORTANT: Do not let skin come in contact with transmission oil and do not inhale fuel vapors. Wear protective gloves. Ensure adeq ...

    Other materials:

    BMW X3 Service & Repair Manual > Rear axle: Adapter
    Adapter AM NOTE: Adapter M4 (Ø 96mm) in connection with adapter kit 2 (BMW), (81642155746), for removal and installation of wheel bearings, propeller shafts and drive flanges. SI number 08 06 09 (544) Adapter AM NOTE: Adapter R7 (M24/Ø 87/95mm) in connection with adapter kit F03 (81 6 ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2024 Copyright www.bmwx3tech.com - 0.0079