BMW X3 (F25) Service & Repair Manual: Hydr/el control components/elements

BMW X3 (F25) Service & Repair Manual / Transmission / Hydr/el control components/elements

Replacing oil accumulator (GA8HP45Z)

IMPORTANT:

  • Do not let skin come in contact with transmission oil and do not inhale fuel vapors.
  • Wear protective gloves.
  • Ensure adequate ventilation.

IMPORTANT: Applicable to vehicles from 08/2011 Remove transmission oil sump only after it has cooled down.

After completion of repair work, check TRANSMISSION OIL LEVEL .

Use only the approved TRANSMISSION OIL .

Failure to comply with this requirement will result in serious damage to the automatic transmission!

Installation note: The transmission oil sump must be renewed every time it is removed.

Necessary preliminary tasks:

  • REMOVE TRANSMISSION OIL SUMP.

Recycling:

Catch and dispose of escaping transmission oil.

Observe country-specific waste disposal regulations.

Release screws (1) (M6x20).

Release screw (2) (M6x59).

Carefully unlock connector (3) with screwdriver.

Carefully pull out oil accumulator.

IMPORTANT: Mounting bolts of oil accumulator must be replaced after removal.

Transmission

Replacing oil reservoir (GA8HP70Z)

IMPORTANT:

  • Do not let skin come in contact with transmission oil and do not inhale fuel vapors.
  • Wear protective gloves.
  • Ensure adequate ventilation.

IMPORTANT: Valid for vehicles manufactured from 08/2011 onward! After completion of repair work, check TRANSMISSION OIL LEVEL .

Use only the approved TRANSMISSION OIL .

Failure to comply with this requirement will result in serious damage to the automatic transmission!

Necessary preliminary tasks:

  • Remove transmission oil sump.

Release screws (1) (M6x20).

Release screw (2) (M6x59).

Carefully unlock connector (3) with screwdriver.

Carefully pull out oil accumulator.

IMPORTANT: Mounting bolts of oil accumulator must be replaced after removal.

Transmission

Mechanical attachments
REPLACING SHAFT SEAL FOR SELECTOR SHAFT (GA8HP45Z) Special tools required: 24 5 362 24 5 366 24 5 367 IMPORTANT: Do not let s ...

Oil pump
REPLACING TORQUE CONVERTER RADIAL SHAFT SEAL (GA8HP45Z) Special tools required: 00 1 450 13 5 250 24 0 200 24 1 420 24 2 410 24 1 410 ...

Other materials:

BMW X3 (F25) Service & Repair Manual > Suspension: Springs with suspension
REMOVING AND INSTALLING/REPLACING REAR LEFT OR RIGHT COIL SPRING Installation note: 1. All screws, nuts, bolts and hose clamps removed during the repair must be replaced. 2. Retaining elements on chassis and suspension and steering parts must be replaced. IMPORTANT: Both coil sp ...