BMW X3 Service & Repair Manual: Installing exchange transfer box (atc 45l)

BMW X3 Service & Repair Manual / Transmission / Transfer box / Installing exchange transfer box (atc 45l)

IMPORTANT: Before and after replacement, execute the "Repair" service function with the BMW diagnosis system.

Recycling: Catch and dispose of escaping transmission oil. Observe country-specific waste disposal regulations Necessary preliminary tasks:

  • Drain GEAR OIL at oil drain plug.
  • Remove TRANSFER BOX.

Remount the following parts:

  • Covers and protective caps
  • Drive shaft transportation retainer
  • Vent hose of transfer box.
  • REPLACE RUBBER MOUNT FOR TRANSFER BOX MOUNTING IF REQUIRED .

IMPORTANT: After completing work, check gear oil level and top up if necessary.

Undo oil filler plug (1).

Check oil level.

Top up transmission oil up to lower edge of opening for oil filler plugs (1).

Use only approved GEARBOX OIL .

Transmission

Failure to comply with this requirement will result in serious damage to the transfer box.

After replacement: Repair service function CARRY OUT PROGRAMMING/ENCODING .

    Installing distributor exchange transmission (atc 450)
    IMPORTANT: Before and after replacement, execute the "Repair" service function with the BMW diagnosis system. Recycling: Catch and dispose ...

    Removing and installing transfer box (atc 450)
    Special tools required: 00 2 030 23 4 050 IMPORTANT: Before and after replacement, execute the "Repair" service function with the BMW di ...

    Other materials:

    BMW X3 Service & Repair Manual > Ignition coil: Replacing ignition coils (N20)
    Necessary preliminary tasks: Read out the fault memory of the DME control unit. Check stored fault messages and process procedure. Switch off ignition. Remove ACOUSTIC COVER IMPORTANT: Ignition coils must not be contaminated by fuel. The resistance of the silicone material is r ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2021 Copyright www.bmwx3tech.com - 0.0089