BMW X3 Owners Manual: Distributing the sealant

Immediately drive approx. 5 miles/10 km to ensure that the sealant is evenly distributed in the tire.

Do not exceed a speed of 50 mph/80 km/h.

If possible, do not drive at speeds less than 12 mph/20 km/h.

To correct the tire inflation pressure

1. Stop at a suitable location.

2. Screw the connection hose of the compressor directly onto the tire valve stem.

3. Insert the connector into the power socket inside the vehicle.

4. Correct the tire inflation pressure to 2.5 bar.

  • Increase pressure: with the ignition turned on or the engine running, reel on the compressor.
  • To reduce the pressure: press the button on the compressor.

Continuing the trip

Do not exceed the maximum permissible speed of 50 mph/80 km/h.

Reinitialize the Flat Tire Monitor.

Reinitialize the Tire Pressure Monitor.

Replace the defective tire and the sealant container of the Mobility System as soon as possible.

    Filling the tire with sealant
    1. Shake the sealing container. 2. Pull the connection hose fully out of the compressor housing. Do not kink the hose. 3. Screw the connect ...

    Snow chains
    Fine-link snow chains Only certain types of fine-link snow chains have been tested by the manufacturer of the vehicle, classified as road-safe and ...

    Other materials:

    BMW X3 Service & Repair Manual > Wheel bearings: Replacing drive flange on left/right rear axle shaft
    Special tools required: 34 4 000 Necessary preliminary tasks: Remove REAR WHEEL . If necessary, remove visual protection cap (1). IMPORTANT: Expand anti-twist lock sufficiently to avoid damaging thread when releasing collar nut. Activate parking brake and release collar nut. ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2019 Copyright www.bmwx3tech.com - 0.0073