BMW X3 Service & Repair Manual: Tpms reminder reset - procedure 1

1. Set the tire pressure on all wheels to specification.

2. Turn ignition switch to ON position, with engine off.

3. Press reset button (for no longer than 10 seconds) until tire pressure warning light illuminates Yellow for a few seconds.

NOTE: On some X5 models, the reset button is marked "RDC".

4. Drive vehicle. Initialization is automatically completed during the drive, without any feedback issued.

DTC

DTC

DTC

    Tire pressure monitor system reminder
    NOTE: If a tire pressure has been adjusted, or a wheel or tire has been changed or replaced, or repairs have been made to air spring suspension, th ...

    Tpms reminder reset - procedure 2
    NOTE: The initialization finishes during driving, which can be interrupted at any time. When driving resumes, the initialization is continued aut ...

    Other materials:

    BMW X3 Service & Repair Manual > Final drive with cover: Replacing radial shaft seal for input flange of rear axle differential
    Special tools required: 33 5 050 33 5 070 33 5 060 00 5 010 33 5 080 33 0 150 IMPORTANT: Use only approved gearbox oils. Failure to comply with this instruction will result in serious damage to the rear axle final drive! Necessary preliminary tasks: Remove PROPELLER S ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2021 Copyright www.bmwx3tech.com - 0.0059