BMW X3 Service & Repair Manual: Removing and installing/replacing actuator drive for central kinematics (a/c control)

BMW X3 Service & Repair Manual / HVAC / Heater with operation / Removing and installing/replacing actuator drive for central kinematics (a/c control)

IMPORTANT: Servomotors must be readdressed in the event of replacement! Addressing can only be carried out with the BMW diagnosis system.

Service functions:

  • Body
  • Heating and air conditioning function
  • Flap motors
  • Readdress flap motors

Necessary preliminary work:

  • Remove RIGHT GLOVE BOX WITH HOUSING

Release screws (1).

Detach actuator drive for central kinematics (2).

Unlock associated plug connection and disconnect.

HVAC

Servomotors must be readdressed in the event of replacement! Addressing can only be carried out with the BMW diagnosis system.

Service functions:

  • Body
  • Heating and air conditioning function
  • Flap motors
  • Readdress flap motors
    Removing and installing (replacing) control panel for heating and air conditioning system
    Necessary preliminary tasks: Remove RADIO AND A/C CONTROL PANEL The following operation describes the replacement. Disconnect plug connectio ...

    Removing and installing radio and a/c control panel
    Special tools required: 00 9 340 IMPORTANT: Risk of damage! A hard disk is installed in the Car Information Computer (CIC). Carry out ...

    Other materials:

    BMW X3 Service & Repair Manual > Driveline+Axles: General information on final drive oil
    1.0 GENERAL INFORMATION ON FINAL DRIVE OIL Final Drive oil or hypoid gear lubricant must conform with the following requirements because of the high loads which occur on the profiles of the hypoid gear teeth: Load carrying capacity. Sufficient protection against seizure. Good wear protec ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2023 Copyright www.bmwx3tech.com - 0.0761