BMW X3 Service & Repair Manual: Removing and installing/replacing sensor for automatic recirculated air control (auc)

BMW X3 Service & Repair Manual / HVAC / Heater with operation / Removing and installing/replacing sensor for automatic recirculated air control (auc)

Necessary preliminary work:

  • REMOVING and installing/replacing right microfilter housing cover

Remove filter cover (1) in direction of arrow.

HVAC

Unfasten plug connection (2) and disconnect.

Unlock retaining tab (1) and remove AUC sensor.

HVAC

Installation note: Retaining tab (1) on AUC sensor (2) must not be damaged.

HVAC

    Removing and installing/replacing heater/air conditioner blower
    Necessary preliminary work: Remove TRIM FOR INSTRUMENT PANEL AT BOTTOM RIGHT Detach right footwell heating duct (1) in direction of arrow from ...

    Removing and installing/replacing servodrive for blending flap (left)
    Necessary preliminary work: Remove SUPPORT FOR DASHBOARD Release screws (1). Remove actuator drive (2). Unlock plug connection (3) and di ...

    Other materials:

    BMW X3 Service & Repair Manual > Propeller shaft assembly: Removing and installing universal joint propeller shaft (inserted) completely
    Special tools required: 00 9 120 00 9 130 33 0 080 33 5 070 IMPORTANT: On four-wheel drive vehicles with defective, non-engaging drive, it is imperative that the following information is taken account of. IMPORTANT: Replacement of the sunk nut on the rear axle final dri ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2022 Copyright www.bmwx3tech.com - 0.0775