Washer AM
NOTE: (Flanged washer) For centring of threaded spindle and as a support disc for removing and installing the rubber mount in the front axle support and in the wishbones - series: E12
Washer AM
NOTE: Contact disc D1 in connection with adapter kit 1 (BMW), (81 64 2 155 745) and MINI adapter kit (81 64 2 294 517), for removal and installation of wheel bearings, propeller shafts and drive flanges.
SI number
08 06 09 (544)
Washer AM
NOTE: (Measuring disc 7 mm)
Washer AM
NOTE: Contact disc (M24) E3 in connection with adapter kit 1 (BMW), (81 64 2 155 745) and MINI adapter kit (81 64 2 294 517), for removal and installation of wheel bearings, propeller shafts and drive flanges.
SI number
08 06 09 (544)
Washer Mechanical tool
NOTE: (Spring washer) For pretensioning the differential side gears when determining the installation size in the front axle differential
Washer Mechanical tool
NOTE: For installing the outer bearing race in the bearing housing in the front axle differential
Washer Mechanical tool
NOTE: For determining the installation play of the radial gears in the front axle differential
WRENCH
Wrench Minimum set: Mechanical tools Mechanical tool
NOTE: For releasing and tightening the shock absorber support bearing bolt
Storage Location
A11
FRONT AXLE - RIDE HEIGHT
FRONT AXLE - RIDE HEIGHT SPECIFICATION
FRONT AXLE DIFFERENTIAL, 170AL/175AL
FRONT AXLE DIFFERENTIAL SPECIFICATION
GENERAL - TRACK WIDTH/WHEELBASE
GENERAL - TRACK WIDTH/WHEELBASE SPECIFICATION
ANTI-ROLL BAR
TIGHTENING TORQUE SPECIFICATION - ANTI-ROLL BAR
FRONT AXLE SUSPENSION
TIGHTENING TORQUE SPECIFICATION - FRONT AXLE SUSPENSION
FRONT AXLE DIFFERENTIAL
TIGHTENING TORQUE SPECIFICATION - FRONT AXLE DIFFERENTIAL
OUTPUT SHAFT
TIGHTENING TORQUE SPECIFICATION - OUTPUT SHAFT
SPRING STRUTS
TIGHTENING TORQUE SPECIFICATION - SPRING STRUTS
TRAILING ARMS AND STRUTS
TIGHTENING TORQUE SPECIFICATION - TRAILING ARMS AND STRUTS
WHEEL BEARINGS AND STEERING KNUCKLE
TIGHTENING TORQUE SPECIFICATION - WHEEL BEARINGS AND STEERING KNUCKLE
TRANSMISSION OIL FOR FRONT AXLE DIFFERENTIAL
FRONT AXLE FINAL DRIVE OILS CHART
GREASE FOR WHEEL BEARING
WHEEL BEARING GREASE CHART
BMW X3 Service & Repair Manual > Engine wiring loom: Replacing wiring harness section for ignition and injectors (N55)
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE
(ESD PROTECTION) .
Necessary preliminary work:
Read out the fault memory of the DME control unit.
Switch off ignition.
Disconnect BATTERY EARTH LEAD .
Remove IGNITION COIL COVER.
Remove CLEAN AIR P ...