Special tools required:
Necessary preliminary work:
Attach special tool 22 1 051 with screw (1) on the housing.
Pull out rubber mount with special tools 22 1 052 /33 4 465 and 33 4 466 .
Installation note:
Observe installation position of rubber mount.
Arrow on rubber mount must point to arrow on housing.
Coat housing bore and rubber mount with Circolight.
Insert special tool 22 1 046 with bolt into recesses of rubber mount.
Draw in rubber mount with special tools 22 1 046 /22 1 053 /33 4 465 and 33 4 466 .
BMW X3 Service & Repair Manual > Oil pressure/oil temperature/oil gauge: Removing and installing/replacing oil pressure sensor (N55)
Necessary preliminary work:
Switch off ignition.
Remove IGNITION COIL COVER.
WARNING: Risk of burning!
Only perform this repair work on an engine that has cooled down.
Installation location:
Oil filter housing, front left.
Engine oil may emerge when oil pressure sensor is replaced; h ...