IMPORTANT: After completing work, check transmission oil level and top up if necessary.
Use only the approved TRANSMISSION OIL .
NOTE:
Installation note:
Determine and note down dimension A of output flange (old and new).
Determine and note down dimension B of output flange (old and new).
Determine old dimension C, thickness of shim.
Installation note:
Calculate thickness of new shim:
1. Add old dimension A of output flange (previous) and old dimension C of shim Then subtract old dimension B from old result A+C.
2. Subtract dimension B from dimension A of output flange (new).
3. Then subtract result of step 2 from result of step 1.
BMW X3 Service & Repair Manual > Steering and wheel alignment: Basic body
Basic body Minimum set: Mechanical tools AM
Basic body AM
NOTE: (Basic body)
BOLT
Bolt AM
NOTE:
(Pressure pin) discontinued, available as part of set of special tools only
Bolt AM
Replaced by: 83300492036
NOTE:
(Measuring bolt) Discontinuation and replaced by 32 2 140. (0 492 036)
...