BMW X3 Owners Manual: Maintaining, storing, and changing the speed

Hints

Adjusting the desired speed

Modify desired speed to road conditions and be ready to brake at all times; otherwise, there is the risk of an accident.

Differences in speed

Large differences in speed relative to other vehicles cannot be compensated by the system such as in the following situations:

  • When fast approaching a slowly moving vehicle.
  • When another vehicle suddenly swerves into the wrong lane.
  • When stationary objects are approached at high speed.

Maintaining/storing the speed

Press button.

Or:

BMW X3. Maintaining/storing the speed

Press the rocker switch while the system is interrupted.

When the system is switched on, the current speed is maintained and stored as the desired speed.

This is displayed in the speedometer and briefly in the instrument cluster. Displays in the instrument cluster.

When cruise control is maintained or stored, DSC Dynamic Stability Control will be turned on if needed.

Changing the speed Press the rocker switch up or down repeatedly until the desired speed is set.

If active, the displayed speed is stored and the vehicle reaches the stored speed when the road is clear.

  • Each time the rocker switch is pressed to the point of resistance, the desired speed increases or decreases by approx. 1 mph/1 km/h.
  • Each time the rocker switch is pressed past the point of resistance, the desired speed increases or decreases by a maximum of 5 mph/10 km/h.

Hold the rocker switch in position to repeat the action.

    Switching on/off and interrupting cruise control
    Switching on Press button on the steering wheel. The indicator lights in the instrument cluster light up and the mark in the speedometer is set ...

    Distance
    Select a distance Adjust the distance according to the traffic and weather conditions; otherwise, there is the risk of an accident. Maintain the pr ...

    Other materials:

    BMW X3 Service & Repair Manual > Troubleshooting: Contents of engine electrical system general
    General Information WORKING ON IGNITION SYSTEM REMOVING AND INSTALLING ELECTRONIC CONTROL UNITS WELDING WORK (overload protection of control units) Disconnecting and connecting battery DISCONNECTING AND CONNECTING TEST EQUIPMENT COMPONENT INSPECTION EXTERNAL JUMP-STARTING AID Comp ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2024 Copyright www.bmwx3tech.com - 0.0312