While driving
Press button with the system switched on.
In the following cases, the stored speed value is deleted and cannot be called up again:
While standing The system brought the vehicle to a complete standstill:
To accelerate to the desired speed automatically, press the accelerator or press the RES or SET button.
Rolling bars in the distance display indicate that the the vehicle detected by the radar sensor has driven off.
Your vehicle was brought down to a halt through stepping on the brake pedal and it is standing behind another vehicle:
1. Press button to call up a stored desired speed.
2. Release the brake pedal.
3. Step on the accelerator briefly, or press the RES rocker switch when the vehicle ahead of you drives away.
BMW X3 Service & Repair Manual > Rear axle: Adapter
Adapter AM
NOTE: Adapter M4 (Ø 96mm) in connection with adapter kit 2 (BMW), (81642155746),
for removal and installation of wheel bearings, propeller shafts and drive
flanges.
SI number
08 06 09 (544)
NOTE: Adapter R7 (M24/Ø 87/95mm) in connection with adapter kit F03 (81 64 2 348
804 ...