BMW X3 Owners Manual: Radar sensor

For US owners only The transmitter and receiver units comply with part 15 of the FCC/Federal Communication Commission regulations. Operation is governed by the following: FCC ID:

  • OAYARS3-A

Compliance statement: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

  • This device may not cause harmful interference, and
  • this device must accept any interference received, including interference that may cause undesired operation.

Any unauthorized modifications or changes to these devices could void the user's authority to operate this equipment.

    System limits
    Speed range The system is best used on well-constructed roads. The minimum speed that can be set is 20 mph/30 km/h. The maximum speed that can ...

    Malfunction
    The system cannot be activated if the radar sensor is not aligned correctly. This may be caused by damage incurred during parking, e.g. A Check ...

    Other materials:

    BMW X3 Service & Repair Manual > Stabilizer bar: Removing and installing/replacing rear anti-roll bar
    Remove BOTH ANTI-ROLL BAR LINKS FROM ANTI-ROLL BAR. Lower REAR AXLE SUPPORT. NOTE: To simplify the graphic, anti-roll bar removal is shown on the removed rear axle. Release screws (1). Remove both RUBBER MOUNTS FROM ANTI-ROLL BAR. Turn anti-roll bar (2) and remove from the side. In ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2024 Copyright www.bmwx3tech.com - 0.0304