Sensors and special algorithms take into account the driving conditions of your vehicle.
Based on this, Condition Based Service recognizes the maintenance requirements.
The system makes it possible to adapt the amount of maintenance corresponding to your user profile.
Detailed information on service requirements, can be displayed on the Control Display.
Service data in the remote control
Information on the required maintenance is continuously stored in the remote control.
Your service center will read out this data and suggest the right array of service procedures for your vehicle.
Therefore, hand your service specialist the remote control with which the vehicle was driven most recently.
Storage periods
Storage periods during which the vehicle battery was disconnected are not taken into account.
If this occurs, have a service center update the time-dependent maintenance procedures, such as checking brake fluid and, if needed, changing the engine oil and the microfilter/ activated-charcoal filter.
Service and Warranty Information Booklet for US models and Warranty and Service Guide Booklet for Canadian models
Please consult your Service and Warranty Information Booklet for US models and Warranty and Service Guide Booklet for Canadian models for additional information on service requirements.
Maintenance and repair should be performed by your service center. Make sure to have regular maintenance procedures recorded in the vehicle's Service and Warranty Information Booklet for US models, and in the Warranty and Service Guide Booklet for Canadian models.
These entries are proof of regular maintenance.
BMW X3 Service & Repair Manual > Steering and wheel alignment: Holder
Holder Mechanical tool
NOTE:
(Counter support) For drift 32 1 140 when driving out the radial shaft seal
together with bearing from the bearing bush
Storage Location
A13
SI number
01 05 95 (932)
HOLDING SLEEVE
Holding sleeve AM
Holding sleeve AM
NOTE: (assembly sleeves) For fitting t ...