Special tools required:
Necessary preliminary tasks:
Completely fill centring bore hole (1) with viscous grease.
Drive special tool 11 1 310 with a plastic hammer into centring bore hole.
The centring bearing (1) is forced out of the propeller shaft by the pressure on the grease filling.
If necessary, top up grease repeatedly.
NOTE: To drive out the bearing, you can also fill the centring bore hole with water instead of grease.
Installation note: Remove grease or water from mount bore.
Drive in centring mount (1) with special tools 11 2 030 and 00 5 500 into propeller shaft (observe protrusion).
Grease centring mount.
Installation note: Observe protrusion A = 4+2 mm of centring (1).
BMW X3 Service & Repair Manual > Automatic transmission: Ring
Ring Minimum set: Mechanical tools Mechanical tool
NOTE:
(Assembly ring) For pressing in the radial seal of the gearshift shaft
Storage Location
B3
SI number
01 04 91 (372)
Ring AM
NOTE: (Retaining ring)
Storage Location
C23
SI number
01 02 07 (334)
NOTE:
(Clamping ring) ...